Currency: GBP
GBP USD EUR JPY AUD NOK CHF NZD CAD BTC
Conversions are estimates and updated daily.
You must be logged in to use your wishlist!

STEMMA Wired Potentiometer Breakout Board - 10K ohm Linear

For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!). Read more...

  • Description

For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!).

This plug-n-play pot comes with a JST-PH 2mm connector and a matching  JST PH 3-Pin to Male Header Cables - 200mm, so wiring up is a cinch. Simply plug the cable in, then use the black wire to connect to your ground, white wire to the input/signal pin and the red wire to your power pin. The power pin voltage should match the voltage max of your analog input. So, if you're using a 5V Arduino or compatible, connect red to 5V. If you're using a 3V Feather board, tie red to 3V.

TECHNICAL DETAILS

  • PCB Dimensions: 28mm x 21mm
  • Potentiometer (L x W x H): 11.8mm x 10mm x 20mm


English