BIG ASK! If you ❤️ shopping with us then please review us on Trust Pilot today!
If you ❤️ shopping with us please review us on Trust Pilot!

4tronix RoboHat2-ZERO

by 4tronix

The RoboHAT2 range is the replacement for the venerable RoboHat motor controller and uses the same pins from the Raspberry Pi. It is a complete robotics controller for your Raspberry Pi based mobile robot.

Just look at the features provided in this small board:

  • LED indication of 5V power status
  • High efficiency, dual H-Bridge driver to drive 2 DC motors (or 2 sets of 2 if using paired motors on each side of the robot)
  • 6, 5V level shifted GPIO inputs with GVS 3-pin connectors (Ground, Volts, Signal)
  • 4, 5V level shifted GPIO outputs with GVS 3-pin connectors
  • Separate power for motors (up to 11V and 1A per motor)
  • The output connectors can be used directly to drive servos
  • Python library module and examples freely available. Uses existing RoboHat library - no pin changes from version 1 to version 2

This controller board is supplied fully assembled. No soldering is required.