Raspberry Pi & Maker goodies
Curated range of best of breed products.
Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.
This is a simple, 6ft. 3.5mm audio cable. Commonly used with audio, this cable can also be used for really easy data transmission, as well as analog voltages.
This is your simple three conductor sensor cable with electrode pad leads.
This is a simple cable that adapts from a USB port to a 5.5x2.1mm barrel connector, center positive. This cable allows the user to use a USB port on a computer, laptop, or on our cigarette power supply to provide our development boards with 5V.
The FTDI cable is a USB to Serial (TTL level) converter which allows for a simple way to connect TTL interface devices to USB. The I/O pins of this FTDI cable are configured to operate at 5V.
Sometimes it’s hard to get power to your Ethernet devices. Wouldn’t it be convenient to use the same cable for power and data? Using these power over Ethernet adapters, you can do just that!
This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end.
This is an interface cable for the Bus Pirate, designed to connect to its 2x5 I/O header.
We use barrel jacks a lot around here and sometimes we need to pop a switch into the mix.That usually means hacking up a perfectly good barrel jack extension cable, but the whole point of using the barrel jacks was so that we wouldn’t have to hack things apart… Well, we found a solution: The Barrel Jack Power Switch.